GRIPPYTRACK SETUP
How to position and attach GrippyTrack to your snowboard.
Step 1: Clean the Surface
Use rubbing alcohol to clean the mounting area on your snowboard. Allow the surface to dry completely.
Step 2: Measure the Placement
Measure ½ to ¾ inch from the toe-side edge of your snowboard. This is where the front edge of GrippyTrack should sit. The front edge is the side of the device from which the track extends when deployed.
Step 3: Position GrippyTrack
Peel off the adhesive backing and carefully position GrippyTrack between your rear binding and the center of the board.
For best performance and stability, we recommend placing it closer to the center of the board to minimize unwanted board rotation during use.
Step 4: Test
Slide the track forward toward the toe-side edge and back into its stored position a few times to ensure smooth operation.
Step 5: Secure GrippyTrack
Once you’re satisfied with the position, press firmly to secure GrippyTrack to your snowboard.
That’s it! Your GrippyTrack is installed and ready to go.
How to safely remove the prototype from your board.
Step 1: Extend the Track
Slide the track forward approximately halfway out of its stored position.
Step 2: Remove the Track
Gently pull back the retaining lip on the base to release the track, then slide the track completely out of the base.
Step 3: Remove the Base
Use a plastic or metal scraper, or a similar tool, to carefully lift one corner of the base from the snowboard’s surface.
Once the corner is lifted, slowly peel the rest of the base away from the board. If using a metal scraper, take extra care to avoid scratching the snowboard’s surface.
Step 4: Remove the Adhesive
Peel off the remaining adhesive tape from the bottom of the GrippyTrack base. Remove any adhesive residue from the snowboard’s surface.
Reinstalling GrippyTrack
If you plan to reinstall GrippyTrack, replace the original adhesive with fresh Gorilla gray double-sided mounting tape or a similar strong, weather-resistant mounting tape.
Make sure both mounting surfaces are clean and dry before reinstallation.
That’s it! Your GrippyTrack is removed and ready to be reinstalled when needed.
Questions or issues?
If anything doesn’t look or feel right, stop using the prototype and reach out to us at testing@grippytrack.com.